Main Article Content
Abstract
Design of tooth profile for the big gear enough usually unlike small gear. Process of tooth making is different. The small gear, its tooth making use the machinery process by cutter module, while for the big gear is making to the casting process. One of the method able to be applied in big design gear by using coordinate system.
Intention of design of diametrical tooth profile with the coordinate systems is to fulfill the big gear ordering requirement. This method is very benefit to all designer in industry because can be easier in big tooth profile making, so that can fulfill the customer needs.
Form the tooth profile for spur gear of coordinate systems with the pressure angle 20 is very good and have sturdy at root tooth. By that is suitable used for big force and low rotation
Keywords : Tooth profile, cicloide, evolvente, coordinate systems
Article Details
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).